Sakura

The challenge at  creative knockouts is to use die cuts punches, stencils with a image from Star Stampz I am working with this image sakura cherry blossom

As I was having a spring clean of my craft room(out with the old in with the new) I donated a lot of stuff I no longer need or use to the local primary school. I found this 3D Diorama Die I have only used it once and thought it would look good with the image  

Unfortunately this is not a good photo it is rather flat 

 

Now this started off being a card but a granddaughter thought it would look nice hanging on her wall so a board is to be made and this will be adhered to this card? 

I coloured the image with copics cut an extra two so I could 3D her

This is the back piece the tags get cut off                 First panel tags also off

 I cut four panels  tags on                                           Side pieces

                                                                                   The tags go into this panel                                                                                                                  

                                             

I adhered the coloured image to the first panel then 3D the girl, each panel of the four has a stem of blossom adhered to the back of the panel I cut them with the scan n cut so I could put a border around the stem, the front panel has a bit of blossom poking over the bottom the top is a row of birds on a branch I also kindy glitzed the flowers it is much easier if you decorate  each panel before putting the card together

The tags slip into the  the cuts in the panel ( I have coloured it blue so they could be seen ) once all in place it keeps the card together